Drone Sub250 Nanofly20 DJI O4 HD 2S
Key features:
- Model: Drone Sub250 Nanofly20 DJI O4 HD 2S
- Make Sub250
- Micro drone 2"
- Very light (less than 100 g)
- Manable and fluid
- DJI O4 Air Unit Pro
- Receiver at choice
- Works with a LiPo 2S
- Guarantee: 2 years
1x Drone Sub250 Nanofly20 DJI O4 HD 2S
1x Spare propeller set
1x Battery holder
1x M2 screwdriver
1x Allen key
1x Spare screw set
1x User manual
1x Sticker set
| Drone | |
| Wheelbase | 88 mm |
| Weight | Approximately 77 g (without battery) |
| Carbon frame thickness | 1.5mm |
| Flight controller | Redfox A2 12A ELRS 2.4GHz AIO Flight Controller |
| MCU | STM32F411 |
| ESC | ESC Bluejay O-H-5 96K |
| Gyro | ICM42688-P |
| Motors | 14,000 KV Sub250 1002 Motors |
| Propellers | 51mm 3-Blade HQProp Propellers |
| VTx | DJI O4 Air Unit Pro |
| Connector | XT30 |
| Supplier-recommended battery | 2S 500mAh 95C LiPo |
| Air Unit | |
| Dimensions | Transmitter module: 30 x 30 x 6 mm Camera module: 13.44 x 12.36 x 16.5 mm Coaxial cable: 50 mm 3-in-1 cable: 50 mm Antenna: 80 mm |
| Weight | Transmitter module (without camera module): approximately 5.1 g Transmitter module (without camera module): approximately 8.2 g* Antenna: approximately 0.75 g *Lens mount not included. With the lens mount, the weight is 9.2 g. |
| Video Transmission | |
| Operating Frequency | 5.170 to 5.250 GHz 5.725 to 5.850 GHz The permitted operating frequency varies by country and region. Please refer to local laws and regulations for more information. |
| Transmitter Output Power (EIRP) | 5.1 GHz: < 23 dBm (CE) 5.8 GHz: < 30 dBm (FCC), < 14 dBm (CE), < 30 dBm (SRRC) |
| Lowest Latency | With DJI Goggles 3 in Racing Mode: With 1080p 100 fps video transmission quality, latency is as low as 20 ms. With DJI Goggles N3 in Racing Mode: With DJI Goggles 2 or DJI Goggles Integra: *Latency data represents the minimum latency during the DJI Goggles screen refresh process. Tested in an open, outdoor environment without interference. Video transmission latency data varies by device. |
| Maximum video transmission range | With DJI Goggles 3/DJI Goggles N3: 10 km (FCC), 6 km (CE), 6 km (SRRC) Measured in an unobstructed, interference-free outdoor environment. The data below represents the longest communication range according to various standards. The actual maximum communication range during flight is limited by the aircraft’s flight endurance. Always pay attention to the RTH reminders in the app during your flight. |
| Antenna | 1 antenna, 1 T1R |
| Channels | Supported Audio Mode
Supported Manual Mode: |
| Channel information | FCC/SRRC/CE: 60MHz/40MHz: Channel 1: 5794.5 MHz 20MHz/10MHz: |
| Camera | |
| Image sensor | 1/2 inch CMOS image sensor |
| Lens | FOV: 117.6° Equivalent Focal Length: 14 mm Aperture: f/2.8 Focus: 0.6 m to ? |
| ISO Range | 100 to 6400 (Auto) 100 to 12800 (Manual) |
| Video Resolution | 4K (4:3): 3840 x 2880 @ 30/50/60 fps 4K (16:9): 3840 x 2160 @ 30/50/60 fps 1080P (4:3): 1440 x 1080 @ 30/50/60/100/120 fps 1080P (16:9): 1920 x 1080 @ 30/50/60/100/120 fps |
| Video format | MP4 |
| Video bit rate | 100 Mbps |
| Color Mode | Normal Mode |
| Camera FOV | Standard and Wide Angle |
| EIS | RockSteady 3.0+ Stabilization feature off (Gyroflow supported) When RockSteady is enabled, the shooting angle only supports standard. |
| Material | |
| Food | 3.7 to 13.2 V |
| Operating temperature | – 10 to 40°C |
| Storage | |
| Internal storage | 23 Go |
| SD Card Supported | No |
| Compatibility | |
| Flight Control System Supported | BetaFlight 4.3.0 and above |
| DJI Goggles and Remote Controllers | DJI Goggles 3 + DJI FPV Remote Controller 3 DJI Goggles N3 + DJI FPV Remote Controller 3 DJI Goggles 2/DJI Goggles Integra + DJI FPV Remote Controller 2 The flight controller firmware must be configured to support the SBUS protocol to use the DJI FPV Remote Controller. |
Questions / Answers
You have a question? One of our experts or our customers will answer you
aymeric gros on 28 October 2025
Équipe LCE
on 28 October 2025
Report Abuse
1
0
